77
Occupancy Sensor Function Settings
Setup the controller’s occupancy sensor.
1. Tap the Occupancy Sensor button to access the occupancy sensor function settings screen.
2. Slide the button on the right of Occupancy Sensor to select whether to enable the occu-
pancy sensor function.
3. Slide the button below Delay to select the duration of the detection of the unoccupied status.
4. Slide the button below Unoccupied Setpoint Oset and select the temperature change value
when unoccupied status is detected.
5. Tap the drop-down button on the right of Heating Set Back and select the temperature limit
to enter the set back operation period.
Figure 101. Occupancy Sensor Function Settings
To Next Page
Loading...
