Lenovo HR650X V2 - View System Event Log

Table 48. BMC network configuration details (continued)
Configuration Address Source Don't change/Static/
DynamicBmcDhcp
Select to configure LAN channel parameters statically or
dynamically (by BIOS or BMC). Unspecified option will
not modify any BMC network parameters during BIOS
phase.
VLAN_ID
N/A
-
Current Configuration Address
Source
N/A
-
Station IP Address N/A
-
Subnet Mask N/A
-
Station MAC Address N/A
-
Router IP Address
N/A
-
Router MAC Address N/A
-
Configure IPV6 Support N/A
-
Lan Channel 8 (Share NIC) N/A
-
IPV6 Support Disabled/Enabled Enable or disable LAN1 IPV6 support.
IPV6 Support Is Disabled N/A
-
Lan Channel 1 (Dedicated NIC) N/A
-
IPV6 Support Disabled/Enabled Enable or disable LAN2 IPV6 support.
Configuration Address Source Don't change/Static/
DynamicBmcDhcp
Select to configure LAN channel parameters statically or
dynamically (by BIOS or BMC). Unspecified option will
not modify any BMC network parameters during BIOS
phase.
Current Configuration Address
Source
N/A
-
Station IPV6 Address N/A
-
Prefix Length N/A
-
IPV6 Address Atatus
N/A
-
IPV6 DHCP Algorithm N/A
-
Configuration Router Lan2
Address Source
Don't change/Static/
DynamicBmcDhcp
-
Current Router Configuration
Address Source
DynamicAddressBmcDhcp
N/A
-
IPV6 Router IP Address
N/A
-
IPV6 Router Prefix Length N/A
-
IPV6 Router Prefix Value N/A
-
View system event log
See the table below for the descriptions of options in View System Event Log screen:
Chapter 5. BIOS setup 135