Clearing system configuration
In event of any of the following, clear the current system configuration and restore the system to its default
settings.
• The system malfunctions after the default hardware configuration was changed, e.g. after adding/
removing a network card or memory module.
• “CPU Fail” or other error messages are displayed on the screen during the startup self-test.
• The system malfunctions after the BIOS settings were changed (unable to start up the server).
• Error in system configuration due to sudden power outage.
Contact your local Lenovo service center to have the above procedures performed at your site.
Replacing the system board battery
The server battery should be replaced if missing server configuration error occurs frequently, system startup
is unstable, or the error message: "CMOS Battery Fails" is displayed on the screen during the startup self-
test. Contact your local Lenovo service center to have the server battery replaced at your site.
After replacing the battery, restart the system. To reset system configuration, enter the system BIOS, then
select Load Default Settings.
172
HR650X V2 User Guide
To Next Page
Loading...
