Step 2. Slide the release latch to the left to open the drive tray handle.
Figure 4. 2.5-inch hot-swap drive
Figure 5. 3.5-inch hot-swap drive
Step 3. Grasp the handle and slide the drive out of the drive bay.
Figure 6. 2.5-inch hot-swap drive
Figure 7. 3.5-inch hot-swap drive
After you finish
1. Install a new drive or drive filler to cover the drive bay. See “Install a hot-swap drive” on page 29.
2. If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.
Install a hot-swap drive
Use this information to install a hot-swap drive.
About this task
Attention:
• Read “Installation Guidelines” on page 25 to ensure that you work safely.
Chapter 4. Hardware replacement procedures 29
To Next Page
Loading...
