If you are instructed to return the old front I/O assembly, follow all packaging instructions and use any
packaging materials that are provided.
Install the front I/O assembly
Use this information to install the front I/O assembly.
About this task
The following illustrates how to install the front I/O assembly with diagnostics panel. You can install other
front I/O assemblies in the same way.
Attention:
• Read “Installation Guidelines” on page 25 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the front I/O assembly to any unpainted surface
on the outside of the server. Then, take the front I/O assembly out of the package and place it on a
static-protective surface.
Step 2. Insert the front I/O assembly into the front chassis.
Figure 29. Rack latch installation
Step 3. Install the screws to secure the front I/O assembly in place.
Chapter 4. Hardware replacement procedures 51
To Next Page
Loading...
