Lenovo ThinkSystem DM3010H - 6.4. Run Installation Diagnostics

•
[ ] (brackets)
Indicate that the element inside the brackets is optional.
•
{ } (braces)
Indicate that the element inside the braces is required.
You can also type the question mark at the command line for a list of all the commands that are
available at the current level of administration (administrative or advanced).
The following example shows the result of entering the environment help command at the storage
system command line. The command output displays the syntax help for the environment
commands.
toaster> environment help
Usage: environment status |
[status] [shelf [<adapter>]] |
[status] [shelf_log] |
[status] [shelf_stats] |
[status] [shelf_power_status] |
[status] [chassis [all | list-sensors | Fan | Power | Temp | Power Supply | RTC Battery | NVRAM4-
temperature-7 | NVRAM4-battery-7]]
6.4. Run system installation diagnostics
You run diagnostics after an initial system installation to identify the version of
system-level diagnostics and the supported devices on your storage system,
and to verify that the installation is successful and that all hardware is
functioning properly.
Your storage system must already be running Data ONTAP.
1.
At the storage system prompt, switch to the LOADER prompt:
halt
2.
Enter the following command at the LOADER prompt:
boot_diags

You must run this command from the LOADER prompt for system-level
diagnostics to function properly. The boot_diags command starts special
drivers designed specifically for system-level diagnostics.
3.
View the version of system-level diagnostics present on your storage system by entering the
following command:
sldiag version show
The version is displayed in the format System Level DiagnosticsX.nn.nn. The X is an alpha
reference and nn.nn are major and minor numeric references, respectively.
104