Lenovo ThinkSystem DM3010H - Step 3: Remove the Mezzanine Card; Step 4: Move the Boot Media


Do not plug the battery in yet. You will plug it in once the rest of the
components are moved to the replacement controller module.
Step 3: Remove the mezzanine card
Remove the mezzanine bezel and PCIe mezzanine card from the impaired controller module.
PUSH
1
2
a
x 3
b
Mezzanine bezel
PCIe mezzanine card
1.
Remove the mezzanine card bezel by sliding it straight out from the controller module.
2.
Loosen the thumbscrews on the mezzanine card.

You can loosen the thumbscrews with your fingers or a screwdriver.
3.
Lift the mezzanine card straight up and set it aside on an anti-static surface.
Step 4: Move the boot media
Remove the boot media from the impaired controller module and install it in the replacement
controller module.
1.
After removing the mezzanine card, locate the boot media using the following illustration or the
FRU map on the controller module:
53