3.
Set up your account:
a.
Log in to your existing account or create an account.
b.
Register your system through
Lenovo Product Registration
4.
Inventory and make a note of the number and types of cables you received.
The following table identifies the types of cables you might receive. If you receive a cable not
listed in the table, see the
Lenovo Press to locate the cable and identify its use.
Type of cable…
Connector type
For…
25 GbE Cable
(order dependent)
or
Cluster interconnect network
Data
RJ-45 (order
dependent)
Management network and Ethernet
data
Storage (order
dependent)
Storage
USB-C Console
cable
Console connection during software
setup
Power cables Powering up the system
5.
Download and complete the worksheets found in Set up the cluster with the ONTAP CLI.
4.2.2. Step 2: Install the hardware
You need to install your system in a 4-post rack or Lenovo system cabinet, as applicable.
Steps
1.
Install the rail kits, as needed. Refer to DM/DE Series 2U12 rail kit installation instructions.
2.
Install and secure your system using the instructions included with the rail kit.
You need to be aware of the safety concerns associated with the weight of
the system.
16
To Next Page
Loading...
