Lenovo ThinkSystem DM3010H - Step 4: Reinstall the Controller Module

PUSH
PUSH
PUSH
1
2
Battery release tab
Battery power connector
4.
Remove the failed battery from the controller module:
a.
Press the blue button on the side of the controller module.
b.
Slide the battery up until it clears the holding brackets, and then lift the battery out of the
controller module.
c.
Unplug the battery from the controller module
5.
Remove the replacement battery from its package. Install the replacement battery:
a.
Plug the battery plug back into the socket on the controller module.
Make sure that the plug locks down into the battery socket on the motherboard.
b.
Aligning the battery with the holding brackets on the sheet metal side wall.
c.
Slide the battery pack down until the battery latch engages and clicks into the opening on
the side wall.
6.
Reinstall the controller module cover and lock it into place.
Step 4: Reinstall the controller module
After you replace components in the controller module, reinstall it into the chassis.
Steps
1.
If you are not already grounded, properly ground yourself.
2.
If you have not already done so, replace the cover on the controller module.
78