Boot media release button
2.
Remove the boot media:
a.
Press the blue button on the boot media housing to release the boot media from its
housing.
b.
Rotate the boot media up, and then gently pull it straight out of the boot media socket.
Do not twist or pull the boot media straight up, because this could
damage the socket or the boot media.
3.
Install the the boot media to the replacement controller module:
a.
Align the edges of the replacement boot media with the boot media socket, and then gently
push it into the socket.
b.
Check the boot media to make sure that it is seated squarely and completely in the socket.
If necessary, remove the boot media and reseat it into the socket.
c.
Push the blue locking button on the boot media housing, rotate the boot media all the way
down, and then release the locking button to lock the boot media in place.
Step 5: Install the mezzanine card in the replacement controller
Install the mezzanine card in the replacement controller module.
54
To Next Page
Loading...
