Lenovo ThinkSystem DM3010H - NVMEM Battery

8.
With the cam handle in the open position, insert the replacement disk drive into the drive
bay, firmly pushing until the disk drive stops.

Wait a minimum of 10 seconds before inserting a new disk drive. This
allows the system to recognize that a disk drive was removed.

If your platform drive bays are not fully loaded with drives, it is important
to place the replacement drive into the same drive bay from which you
removed the failed drive.

Use two hands when inserting the disk drive, but do not place hands on
the disk drive boards that are exposed on the underside of the disk
carrier.
9.
Close the cam handle so that the disk drive is fully seated into the midplane and the
handle clicks into place.
Be sure to close the cam handle slowly so that it aligns correctly with the face of the disk
drive..
10.
If you are replacing another disk drive, repeat Steps 4 through 9.
11.
Reinstall the bezel.
12.
If you disabled automatice drive assignment in Step 1, then, manually assign drive
ownership and then reenable automatic drive assignment if needed.
a.
Display all unowned drives:
storage disk show -container-type unassigned
You can enter the command on either controller module.
b.
Assign each drive:
storage disk assign -disk disk_name -owner owner_name
You can enter the command on either controller module.
You can use the wildcard character to assign more than one drive at once.
c.
Reenable automatic drive assignment if needed:
storage disk option modify -node
node_name -autoassign on
You must reenable automatic drive assignment on both controller modules.
13.
Return the failed part to Lenovo, as described in the RMA instructions shipped with the kit.
5.6. NVMEM battery
74