Lenovo ThinkSystem DM3010H - Step 4: Reinstall the Controller Module; Step 5: Restore Automatic Giveback and Autosupport; Step 6: Return the Failed Part to Lenovo

Step 4: Reinstall the controller module
Reinstall the controller module into the chassis.
Steps
1.
If you are not already grounded, properly ground yourself.
2.
If you have not already done so, replace the cover on the controller module.
3.
Turn the controller module over and align the end with the opening in the chassis.
4.
Gently push the controller module halfway into the system.

Do not completely insert the controller module in the chassis until instructed
to do so.
5.
Recable the system, as needed.
If you removed the media converters (QSFPs or SFPs), remember to reinstall them if you are
using fiber optic cables.
6.
Complete the reinstallation of the controller module:
a.
With the cam handle in the open position, firmly push the controller module in until it meets
the midplane and is fully seated, and then close the cam handle to the locked position.

Do not use excessive force when sliding the controller module into the
chassis to avoid damaging the connectors.
The controller begins to boot as soon as it is completely seated in the chassis.
b.
If you have not already done so, reinstall the cable management device.
c.
Bind the cables to the cable management device with the hook and loop strap.
Step 5: Restore automatic giveback and AutoSupport
Restore automatic giveback and AutoSupport if they have been disabled.
1.
Restore automatic giveback by using the
storage failover modify -node local -auto
-giveback true command.
2.
If an AutoSupport maintenance window was triggered, end it by using the
system node
autosupport invoke -node * -type all -message MAINT=END
Step 6: Return the failed part to Lenovo
If you are instructed to return the component, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
48