Lenovo ThinkSystem DM3010H - Step 4: Cable Controllers to Drive Shelves

▪ 4-ports, 32Gb Fiber Channel, SFP+
c.
If you have a 2+2 card (2 ports with Ethernet connections and 2 ports with Fiber
Channel connections), cable ports e1a and e1b to your FC data network and ports e1c
and e1d to your Ethernet data network.
▪ 2-ports, 10/25Gb Ethernet (SFP28) + 2-ports 32Gb FC (SFP+)
▪ 2-ports, 32Gb Fiber Channel, SFP+

DO NOT plug in the power cords.
4.2.4. Step 4: Cable controllers to drive shelves
Cable your controllers to external storage.

The example uses DM240S. Cabling is similar with other supported drive shelves.
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
About this task
You can use the graphic or the step-by step instructions to complete the cabling between the
controllers and to the drive shelves.

Do not use port 0b2 on a DM3010H. This SAS port is not used by ONTAP and is
always disabled.
Steps
1.
Cable the shelf-to-shelf ports.
a.
Port 1 on IOM A to port 3 on the IOM A on the shelf directly below.
22