Lenovo ThinkSystem DM3010H - Restore OKM, LSE, and LVE as Needed - DM3010 H

the ONTAP versions.
11.
If you are not using storage encryption, restore automatic giveback and AutoSupport:
a.
Restore automatic giveback if you disabled it by using the
storage failover modify -node
local -auto-giveback true command.
b.
If an AutoSupport maintenance window was triggered, end it by using the
system node
autosupport invoke -node * -type all -message MAINT=END command.
5.1.6. Restore OKM, LSE, and LVE as needed - DM3010H
Once environment variables are checked, you must complete steps specific to
systems that have Onboard Key Manager (OKM), Lenovo Storage Encryption
(LSE) or Lenovo Volume Encryption (LVE) enabled using settings you captured
at the beginning of this procedure.

If LSE or LVE are enabled along with Onboard Key Manager you must restore
settings you captured at the beginning of this procedure.
Steps
1.
Connect the console cable to the target controller.
2.
Use the
boot_ontap command at the LOADER prompt to boot the controller.
3.
Check the console output:
If the console
displays…
Then…
The login prompt Go to Step 7.
Waiting for
giveback…
a.
Log into the partner controller.
b.
Confirm the target controller is ready for giveback with the
storage
failover show command.
4.
Move the console cable to the partner controller and give back the target controller storage
using the
storage failover giveback -fromnode local -only-cfo-aggregates true local
command.
◦ If the command fails because of a failed disk, physically disengage the failed disk, but leave
the disk in the slot until a replacement is received.
◦ If the command fails because of an open CIFS session, check with the customer on how to
close out CIFS sessions.

Terminating CIFS can cause loss of data.
42