If your system has… Then…
No network connection a.
Press
n when prompted to restore the backup
configuration.
b.
Reboot the system when prompted by the system.
c.
Select the Update flash from backup config (sync flash)
option from the displayed menu.
If you are prompted to continue with the update, press
y.
4.
Ensure that the environmental variables are set as expected:
a.
Take the controller to the LOADER prompt.
b.
Check the environment variable settings with the
printenv command.
c.
If an environment variable is not set as expected, modify it with the
setenv environment-
variable-name changed-value command.
d.
Save your changes using the
savenv command.
5.
The next depends on your system configuration:
◦ If your system has onboard keymanager, LSE or LVE configured, go to
Restore OKM, LSE,
and LVE as needed.
◦ If your system does not have onboard keymanager, LSE or LVE configured, complete the
steps in this section.
6.
From the LOADER prompt, enter the boot_ontap command.
If you see… Then…
The login prompt Go to the next Step.
Waiting for giveback…
a.
Log into the partner controller.
b.
Confirm the target controller is ready for giveback with the
storage failover show command.
7.
Connect the console cable to the partner controller.
8.
Give back the controller using the
storage failover giveback -fromnode local command.
9.
At the cluster prompt, check the logical interfaces with the
net int show -is-home false
command.
If any interfaces are listed as "false", revert those interfaces back to their home port using the
net int revert -vserver vserver_name -lif lif_name command.
10.
Move the console cable to the repaired controller and run the
version -v command to check
41
To Next Page
Loading...
