◦ If the command fails because the partner is "not ready", wait 5 minutes for the NVMEMs to
synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the
process. See the appropriate Documentation Center for more information.
5.
Wait 3 minutes and check the failover status with the storage failover show command.
6.
At the clustershell prompt, enter the
net int show -is-home false command to list the logical
interfaces that are not on their home controller and port.
If any interfaces are listed as
false, revert those interfaces back to their home port using the
net int revert -vserver Cluster -lif nodename command.
7.
Move the console cable to the target controller and run the
version -v command to check the
ONTAP versions.
8.
Restore automatic giveback if you disabled it by using the
storage failover modify -node
local -auto-giveback true command.
9.
Use the
storage encryption disk show at the clustershell prompt, to review the output.
10.
Use the
security key-manager key query command to display the key IDs of the authentication
keys that are stored on the key management servers.
◦ If the
Restored column = yes/true, you are done and can proceed to complete the
replacement process.
◦ If the
Key Manager type = external and the Restored column = anything other than
yes/true, use the security key-manager external restore command to restore the key
IDs of the authentication keys.
If the command fails, contact Customer Support.
◦ If the
Key Manager type = onboard and the Restored column = anything other than yes/true,
use the security key-manager onboard sync command to re-sync the Key Manager type.
Use the security key-manager key query to verify that the
Restored column = yes/true for
all authentication keys.
11.
Connect the console cable to the partner controller.
12.
Give back the controller using the
storage failover giveback -fromnode local command.
13.
Restore automatic giveback if you disabled it by using the
storage failover modify -node
local -auto-giveback true command.
14.
Restore Autosupport if it was disabled by using the
system node autosupport invoke -node *
-type all -message MAINT=END
5.1.7. Return the failed part to Lenovo - DM3010H
If you are instructed to return the component, follow all packaging instructions,
43
To Next Page
Loading...
