▪ ata is an Advanced Technology Attachment device.
▪
bootmedia is the system booting device..
▪
cna is a Converged Network Adapter not connected to a network or storage device.
▪
env is motherboard environments.
▪
fcache is the Flash Cache adapter, also known as the Performance Acceleration Module
2.
▪
fcal is a Fibre Channel-Arbitrated Loop device not connected to a storage device or
Fibre Channel network.
▪
fcvi is the Fiber Channel Virtual Interface not connected to a Fibre Channel network.
▪
interconnect or nvram-ib is the high-availability interface.
▪
mem is system memory.
▪
nic is a Network Interface Card not connected to a network.
▪
nvram is nonvolatile RAM.
▪
nvmem is a hybrid of NVRAM and system memory.
▪
sas is a Serial Attached SCSI device not connected to a disk shelf.
▪
serviceproc is the Service Processor.
▪
storage is an ATA, FC-AL, or SAS interface that has an attached disk shelf.
▪
toe is a TCP Offload Engine, a type of NIC.
◦
mb specifies that all the motherboard devices are to be tested.
◦
slot slotnum specifies that a device in a specific slot number is to be tested.
◦
-name device specifies a given device class and type.
4.
View the status of the test by entering the following command:
sldiag device status
Your storage system provides the following output while the tests are still running:
There are still test(s) being processed.
After all the tests are complete, the following response appears by default:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
5.
Verify that no hardware problems resulted from the addition or replacement of hardware
components on your storage system by entering the following command:
sldiag device
status [-dev devtype|mb|slotslotnum] [-name device] -long -state failed
The following example pulls up the full status of failures resulting from testing a newly installed
FC-AL adapter:
115
To Next Page
Loading...
