•
You must use only the screws that are provided in the kit.
steps
a.
Determine where you want to install the enclosure in the rack.Use the rack alignment guide tool
to ensure that you install the enclosure at the same level on either post of the rack.
When possible, install enclosures starting at the bottom of the rack and
working up, so that you can use the enclosures underneath as a guide for
installing the next set of rails.
b.
Remove the M5 screws from each of the rail ends and the side brackets and saved. Make sure
to leave the 8 outer alignment screws (9.4mm head for the square-hole rack) in the rail flanges
for proper alignment in the rack.
i.
If you have a round-hole rack, remove the eight pre-installed square-hole rack alignment
screws and install the eight round-hole rack alignment screws.
Ensure that you use the screws that are appropriate for your rack.
ii.
Place the rail inside the rack where you want to install the enclosure, and align the
alignment screws on the rail with the holes on the front post of the rack.
iii.
Extend the rail to the back post of the rack until the flanges on the rail touch the inside of
the rack.
iv.
Insert one flat-head M5 screw through the hole in the front of the rack, and two flat-head
M5 screws through the holes at the back of the rack.
v.
Repeat these steps for the other rail.
c.
Place the back of the enclosure (the end with the connectors) on the rails.
ATTENTION: A fully loaded enclosure weighs approximately 65 lb (29 kg). Two persons are
12
To Next Page
Loading...
