After this task is completed
1. If necessary, adjust location of the M.2 drive retainer to accommodate another M.2 drive of a different
size (see
“Adjust an M.2 drive retainer” on page 102).
2. Install a replacement unit (see
“Install an M.2 drive” on page 103).
3. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Adjust an M.2 drive retainer
Follow instructions in this section to adjust the position of an M.2 drive retainer on the system board or on the
M.2 boot adapter.
About this task
Sometimes you need to adjust the M.2 drive retainer to a correct keyhole that can accommodate the
particular size of the M.2 drive you wish to install.
Attention:
• Read
“Installation Guidelines” on page 41 and “Safety inspection checklist” on page 42 to make sure that
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. Adjust the position of the M.2 retainer on the system board.
a.
Rotate the retainer by 90 degrees to the unlocked position; then, lift the retainer from the
system board.
b.
Locate the correct keyhole into which the retainer should be installed; then, insert the
retainer into the keyhole, orienting at the unlocked position.
c.
Rotate the retainer by 90 degrees to the locked position.
102
ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
