Lenovo ThinkSystem SR650 - Install the Security Bezel

Figure 58. Security bezel removal
Attention: Before you ship the rack with the server installed, reinstall and lock the security bezel
into place.
Install the security bezel
Use this information to install the security bezel.
Before installing the security bezel, if you have removed the rack latches, reinstall them. See “Install the rack
latches” on page 99.
To install the security bezel, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
Attention: Before you ship the rack with the server installed, reinstall and lock the security bezel into place.
Step 1. If the key is held inside the security bezel, remove it out of the security bezel.
Chapter 3. Hardware replacement procedures 93