Server models with eight 3.5-inch drives
Use this section to understand the cable routing for server models with eight 3.5-inch SAS/SATA drives.
Server model: eight 3.5-inch SAS/SATA drives, the rear hot-swap drive assembly, two 8i RAID
adapters
Note: The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is
installed. Depending on the model, the rear hot-swap drive assembly and the 8i RAID adapter on PCIe slot 4
might not be available on your server.
Figure 52. Cable routing for server models with eight 3.5-inch SAS/SATA drives, the rear hot-swap drive assembly, and
two 8i RAID adapters
78 ThinkSystem SR650 Maintenance Manual
To Next Page
Loading...
