Lenze 8400 motec Series - Initial Switch-on Procedure

Lenze · Decentralised frequency inverter 8400 motec (CANopen option) · EDS84DMOTCAN EN 4.0 - 02/2019 33
Commissioning
Initial switch-on
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.5 Initial switch-on
Establishing communication
• To establish communication, the inverter drive must be supplied with mains voltage.
• CANopen communication requires voltage supply of the communication unit.
If this is requirement is not met, the "CE04: MCI communication error" error message (error No.
01.0127.00002) is output. The error must be reset in the Inverter Drive, so that CANopen
communication can be established.
• During mains connection, all parameters (codes) and the DIP switch settings are read.
• The positions of the DIP switches define whether the CAN node address and the baud rate are
selected via the DIP switches or via codes C00350
and C00351.
Possible settings via DIP switch
( 30)