Lenze 9300 vector - Page 133

Commissioning
Parameter setting with the XT EMZ9371BC keypad
Commissioning example in vector control mode
6
6.3
6.3.2

6.3−8
EDSVF9383V EN 6.0−11/2009
NoteSwitch−on sequence
26. The drive is running now CW rotation:
X5/E1 = HIGH and X5/E2 = LOW
CCW rotation:
X5/E1 = LOW and X5/E2 = HIGH
If the drive does not start, press  in
addition
(see chapter "Commissioning" ®
"Acceleration, deceleration, braking,
stopping")
 Note!
In the "Diagnostic" menu you can monitor the most important
drive parameters
efesotomasyon.com - Lenze