Lenze C520 - Page 87

Parameter
Address Name / seng range / [default seng] Informaon
0x2022:043 Device commands: Restore
•
Seng can only be changed if applicaon status (displayed in
0x5810:001) is not equal to "1: Running".
•
When the device command has been executed successfully, the value
0 is shown.
•
Do not switch o the supply voltage or remove the SD card from the
controller while the data recovery is being executed!
0 O / ready Only status feedback
1 On / start Start data recovery from USB sck.
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Device disabled)
20 20%
40 40%
60 60%
80 80%
100 100%
101 No SD card connected
102 SD card is write protected
103 SD card is full
104 USB sck not mounted
105 Backup le on USB sck wrong, double or in
the wrong path
107 Device no memory space le
Device funcons
Back up and restore data
Restore data
87