Lenze i550 Series - Application as Directed; Handling

Applicaon as directed
•
The pr
oduct must only be operated under the operang
condions prescribed in this documentaon.
•
The pr
oduct meets the protecon requirements of 2014/35/EU: Low-Voltage Direcve.
•
The product is not a machine in terms of 2006/42/EU: Machinery Direcve.
•
Commissioning or starng the
operaon as directed of a machine with the product is not permied unl
it has been ensured that the machine meets the regulaons of the EU Direcve 2006/42/EU: Machinery
Direcve; observe EN 60204−1.
•
Commissioning or starng operaon as directed is only permissible if the EMC Direcve 2014/30/EU is
complied with.
•
The harmonised standard EN 61800−5−1 is applied.
•
The product is not a household appliance, but is only designed as a component for commercial or
professional use in terms of EN 61000−3−2.
•
The product can be used according to the technical data if drive systems have to comply with categories
according to EN 61800−3.
In residenal areas, the product may cause EMC interferences. The operator is responsible for taking
interference suppression measures.
•
The pr
oduct must only be actuated with motors that are suitable for the operaon with inverters.
-
Lenz
e L-force motors meet the requirements
-
Excepon: m240 motors are designed for mains operaon only.
The user is not allowed to change inverters that come with integrated safety technology.
The safety module must not be removed. If the safety module is defecve, the inverter has to be replaced.
Handling
•
Ne
ver commission the product in the event of visible damage.
•
The product must never be technically modied.
•
Ne
ver commission the product before assembly has been completed.
•
The product must never be operated without required covers.
•
Establish, separate and change all electrical connecons only in deenergised state!
Safety instrucons
Handling
113