Lenze i550 Series - Powerlink

POWERLINK
Typical topologies
Line
CN2n
CN22
CN21
CN1n
CN12
CN11
H2
H1
MN
MN Managing Node H Hub
CN Controlled Node
Bus-related informaon
Name Ethernet POWERLINK
Communicaon medium Ethernet 100 Mbps, half duplex
Use Connecon of the inverter to a
PO
WERLINK network
Connecon system RJ45
Status display 2 LEDs
Connecon designaon IN: X286
OUT: X287
Status displays at the RJ45 sockets
The LEDs at the RJ45 sockets indicate the connecon status to the network:
LED (green) Status/meaning
o No
connecon to the network.
on
A physical connecon to the network is available.
ickers
Data is exchanged via the network.
LED (red) Status/meaning
on
POWERLINK collision
Basic network sengs
The rotary encoder switch allows you to set the node address (last byte of the IP address).
x16 x1
Seng Node address Resulng IP address
0x00 Value from parameter 192.168.100.<parameter value>
0x01 ... 0xEF Switch posion 192.168.100.<switch
posion>
Electrical installaon
Networks
PO
WERLINK
177