Multi−axis controllers
Preparing the commissioning procedure
4
237
EDS94SPP101 EN 10.2
4.10 Preparing the commissioning procedure
For commissioning you require:
ƒ A computer with Windows® operating system (XP or 2000)
ƒ The Lenze PC software »Engineer«
ƒ A connection to the controller via an interface, e.g.:
– Diagnostic interface X6 with USB diagnostic adapter
– System bus CAN
– Communication modules in the extension slots MXI1/MXI2
ƒ The Software Manual for the technology application used
ƒ The Communication Manual for the automation platform network
ƒ 24−V voltage supply for control electronics of the controller
ƒ DC−bus voltage
Follow the software instructions and/or read the documentation.
To Next Page
Loading...
