Regenerative power supply modules
Rated data
Fuses and cable cross−sections
6
298
EDS94SPP101 EN 10.2
6.3.6 Fuses and cable cross−sections
Mains Voltage Voltage range Frequency range
U
Lrated
[V] U
Lrated
[V] f [Hz]
3/PE AC 230 ... 480 180 − 0 % ... 528 + 0 % 45 ... 65
Operation with external mains choke/mains filter, installation according to
EN 60204−1
The data are recommendations. Other dimensioning/laying systems are possible (e.g.
according VDE 0298−4).
The cable cross−sections apply under the following conditions:
ƒ Use of PVC−insulated copper cables
ƒ Conductor temperature < 70 °C, ambient temperature < 45°C
ƒ No bundling of cables or cores
ƒ Three loaded cores
Type L1, L2, L3 − laying system FI
1)
B2 C F
[A] [A] [mm
2
] [mm
2
] [mm
2
] [mA]
E94AZMR0264xDB
E94ARNE0134
C32
− 10 6 −
E94AZMR0474xDB
E94ARNE0244
− 80 25 16 −
Circuit breaker
Fuse of the utilisation category gG/gL or semiconductor fuses or the utilisation category gRL
1)
Universal−current−sensitive earth−leakage circuit breaker, RCD type B
If several devices or cable lengths > 50 m are used, it is possible that the circuit breaker will respond, depending on
the type of cable and the switching frequency.
Observe national and regional regulations!
Operation with external mains choke/mains filter, installation according to UL
Only use UL−approved cables, fuses and fuse holders.
UL fuse: Voltage 600 V; CC, J or T class fuses
Type standard installation motor group installation FI
1)
L1, L2, L3 L1, L2, L3
[A] [AWG] [A] [AWG] [mA]
E94AZMR0264xDB
E94ARNE0134
45 6 70 3
E94AZMR0474xDB
E94ARNE0244
70 3 70 3
Fuse
1)
Universal−current−sensitive earth−leakage circuit breaker, RCD type B
If several devices or cable lengths > 50 m are used, it is possible that the circuit breaker will respond, depending on
the type of cable and the switching frequency.
Observe national and regional regulations!
To Next Page
Loading...
