Lenze L-force 9400

Accessories (overview)
Filters
Mains filters for single−axis controllers E94AZMSxxxx 3 ... 31 A
8

540
EDS94SPP101 EN 10.2
Dimensions
SSP94NF005
All dimensions in millimetres.
Mass
[kg]
E94AZMS0034 3.2
E94AZMS0094 5.2
E94AZMS0184 8.4
E94AZMS0314 8.8
Mechanical installation
 Note!
The filter can be mounted in two different variants. This results in differing
mounting dimensions.
ƒ Standard mounting
– The filter is mounted below the mounting base of the basic device. The
grid hole pattern of the L−force 9400 device series can be used.
ƒ Side−by−side mounting for small control cabinet depth
– Device size I: The filter is mounted left to the basic device. The grid hole
pattern of the L−force 9400 device series can be used.
– Device sizes II and III: The filter is turned by 90° and mounted left to the
basic device. The grid hole pattern of the L−force 9400 device series cannot
be used.
For information on this topic, please see the corresponding mounting instructions.