Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 11.0 EN · 04/2016 · TD17 41
6 Commissioning
6.4 Setting the IP configuration
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Decimal representation of the IP parameters
By clicking the [int] buttons on the right next to the input fields, the IP parameters are shown as a
decimal value.
In the case of the decimal representation, the byte sequence is inverted.
Example: IP address 192.168.0.1
C13000
/ C14000 = 16820416 [binary: 00000001.00000000.10101000.11000000]
IP address
Valid IP addresses are defined in accordance with RFC 3330.
The IP address is set/changed in C13000
/ C14000.
In C13010/1...4
/ C14010/1...4 the currently used IP address is shown.
Subnet Mask
The subnet mask indicates which part of the IP address is evaluated as net ID or host ID.
Valid subnet masks are defined in accordance with RFC 1878
The subnet mask is set/changed in C13001
/ C14001.
In C13011/1...4
/ C14011/1...4, the currently used subnet mask is shown.
Byte 3 Byte 2 Byte 1 Byte 0
1 0 168 192
0 0 0 0 0 0 0 1 0 0 0 0 0 0 0 0 1 0 1 0 1 0 0 0 1 1 0 0 0 0 0 0
C13010/4
C14010/4
C13010/3
C14010/3
C13010/2
C14010/2
C13010/1
C14010/1
Example: Display of the IP address 192.168.0.1
Code C13010/1
C14010/1
C13010/2
C14010/2
C13010/3
C14010/3
C13010/4
C14010/4
Value 192 168 0 1
Example: Display of the subnet mask 255.255.255.0
Code C13011/1
C14011/1
C13011/2
C14011/2
C13011/3
C14011/3
C13011/4
C14011/4
Value 255 255 255 0
To Next Page
Loading...
