Description ODSL 30
Leuze electronic ODSL 30 13
TNT 35/7-24V
3.2 Typical Areas of Application for the ODSL 30
3.2.1 Continuous distance measurement
All ODSL 30 variants with analogue/digital or switching output can be used for continuous
distance measuring. The menu-guided configuration via keypad and LC display on the
device without additional software permits the adaptation to a large number of applications.
Depending on position or settings of the ODSL 30, various applications are possible:
• Positioning of side-tracking skates, cranes, lifting devices
• Contour determination through controlled passing movement of an object through the
beam of the ODSL 30.
• Volume measuring by taking measurements on two levels during the concurrent
movement of the object.
• Determination of the diameter, e.g., on paper rolls.
• Measuring the thickness of planks with two opposing sensors and a differential of the
two measured values.
3.2.2 Positioning tasks
The ODSL 30 variants with analogue output and/or up to three teachable switching outputs
are ideally suited for basic positioning tasks, such as the height/level adjustment of elevating
platforms and rising floors.
The ODSL 30 is mounted in a way to enable positioning in the direction of the measuring
beam.
Figure 3.1: Application example Positioning of Elevating Platforms
To Next Page
Loading...
