Technical Data ODSL 30
52 ODSL 30 Leuze electronic
4 Technical Data ODSL 30
4.1 General specifications
ODSL 30
Optical data
Measurement range 200 … 30000mm (6 … 90% diffuse reflection)
200 … 65000mm (50 … 90% diffuse reflection, only
ODSL 30/D…)
Resolution
1)
1) Resolution on the LC display
0.1mm/1mm (factory setting)
Light source laser (modulated light)
Wavelength 655nm (visible red light)
Laser class 2 (in accordance with EN 60825-1)
Light spot diameter divergent, Ø6mm at a distance of 10m
Minimum object size 50x50mm
2
at a distance of 10m (6 … 90% diffuse reflection)
Timing
Measurement time
2)
2) Configurable, depends on the reflectivity of the object and on the max. detection range
30 … 100ms (factory setting: 100ms)
Delay before start-up 1s
Mechanical data
Housing metal
Optics cover glass
Weight 650g
Connection type M12 connector, 8-pin
Environmental data
Ambient temperature
(operation
3)
/storage)
3) After an operating time of 30 min., the device has reached the operating temperature
required for an optimal measurement.
-10 … +45°C / -40 … +70°C
Ambient light limit £ 5kLux
Protective circuit
4)
4) 2=polarity reversal protection, 3=short-circuit protection for all outputs
2, 3
VDE safety class
5)
5) Rating voltage 250VAC
II, all-insulated
Protection class IP 67
Standards applied IEC 60947-5-2
Certifications UL508,C22.2No.14-13
6)
7)
6) For UL applications: only for use in "Class 2" electrical circuits according to NEC
7) These sensors shall be used with UL Listed Cable assemblies rated 30 V, 0.5 A min,
in the field installation, or equivalent (categories: CYJV/CYJV7 or PVVA/PVVA7)
To Next Page
Loading...
