General information
Leuze electronic ODSL 30 5
TNT 35/7-24V
Referencing
Device function of the ODSL 30… for the compensation of a possible temperature
drift. A reference measurement should be carried out before each exact measure-
ment. The reference measurement is activated via a separate device input and is
automatically carried out once after the device is switched on.
Diffuse reflection
Return and/or degree of reflection of the radiated light.
Measurement time
The measurement time is dependent on the selected uniqueness range and the lumi-
nosity coefficient of the object (see chapter 3.8.2).
Delay before start-up
The delay before start-up indicates the point in time when the first valid measurement
can be obtained after switching on.
Light switching/Dark switching
Specifies the behaviour of the switching output: light switching if an object is located
within the configured distance range, dark switching if an object is located outside of
the configured distance range.
Insensitivity towards ambient light
Indicates the insensitivity of the measurement result towards ambient light. The
ODSL 30 is reliably measuring even with extraneous light intensity of 5kLux. Typical
light intensity in a work place is only 1kLux.
1.3 Declaration of conformity
The optical distance sensors of the ODSL 30 series have been manufactured observing
current European standards and guidelines.
Notice
A corresponding Declaration of Conformity can be requested from the manufacturer.
The manufacturer of the product, Leuze electronic GmbH + Co. KG in D-73277 Owen,
possesses a certified quality assurance system in accordance with ISO 9001.
To Next Page
Loading...
