Leuze electronic ODSL 30 Series - Remote Control

Description ODSL 30
Leuze electronic ODSL 30 23
TNT 35/7-24V
Measurement value output for various transmission types
Commands for remote control operation
For remote control operation (parameter Remote Control), a device address between
0 … 14 can be set. In this operating mode, the ODSL 30/D… reacts only to commands from
the controller.
With asynchronous measurement, the sensor measures continuously. After processing
the command, the next measurement value of the ODSL 30 is transmitted. The response
time of the ODSL 30 varies within the scope of the measurement time and is dependent on
the time of the query and the state of the internal measurement cycle of the ODSL 30 at this
time.
With synchronous measurement, the measurement starts with processing of the current
command. The response time of the ODSL 30 is constant and is dependent only on the
configured measurement time.
The following control commands are available:
Object distance
Measurement value output for transmission type
ASCII
5 bytes
ASCII
6 bytes
14 bit 16 bit 20 bit Remote
4 bytes
Remote
5 bytes
Remote
6 bytes
No object (no signal) 65535 655350 16383 65535 655350 9999 65535 655350
<200mm
1)
Distance
value
in mm
Distance
value
in 1/10mm
Distance
value
in mm
Distance
value
in mm
Distance
value
in 1/10mm
Distance
value
in mm
Distance
value
in mm
Distance
value
in 1/10mm
200mm … 9900mm
Distance
value
in mm
Distance
value
in 1/10mm
Distance
value
in mm
Distance
value
in mm
Distance
value
in 1/10mm
Distance
value
in mm
Distance
value
in mm
Distance
value
in 1/10mm
9901mm … 16000mm
Distance
value
in mm
Distance
value
in 1/10mm
Distance
value
in mm
Distance
value
in mm
Distance
value
in 1/10mm
9901
Distance
value
in mm
Distance
value
in 1/10mm
16001mm … 65000mm
Distance
value
in mm
Distance
value
in 1/10mm
16001
Distance
value
in mm
Distance
value
in 1/10mm
9901
Distance
value
in mm
Distance
value
in 1/10mm
> 65000mm 65001 650010 16001 65001 650010 9901 65001 650010
Object distance + Offset
> 65000mm
(Offset Direction neg.)
65001 650010 16001 65001 650010 9901 65001 650010
Object distance - Offset
<0mm
(Offset Direction pos.)
00000000
Device error 00000000
1) Only if a received signal is available that can still be evaluated, otherwise same as "no object"