Leuze electronic ODSL 30 Series - Page 26

Description ODSL 30
24 ODSL 30 Leuze electronic
Commands for the asynchronous measurement
Measurement value query, 4 digits:
Asynchronous measurement value query 5 digits, resolution 1mm:
Asynchronous measurement value query 6 digits, resolution 0.1mm:
Commands for the synchronous measurement
The two following synchronous measurement commands "S" (5-digit measurement value,
resolution 1mm) or "s" (6-digit measurement value, resolution 0.1mm) enable the start of a
measurement at a precise time.
If a synchronous measurement value is requested via remote control operation:
• this command immediately switches on the laser and triggers the measurement.
• following the measurement cycle, the laser is switched off.
• the measured value is transmitted following this measurement cycle.
Notice!
Prerequisite for the function of the synchronous measurement value query is that the sensor
be deactivated (laser off)!
Byte no. Response
time
012345678
Command
Sensor
address
0x00
through
0x0E
––––––––
Sensor
response
"
*
"
(0x2A)
ASCII address ASCII distance measurement value
"#"
(0x23)
–
max.
120ms
tens ones 1'000's 100's tens ones
Byte no. Response
time
012345678
Command
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
"M"
(0x4D)
"#"
(0x23)
–––––
Sensor
response
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
ASCII distance measurement value
State
"#"
(0x23)
max.
120ms
10'000's 1'000's 100's tens ones
Byte no. Response
time
0123456789
Command
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
"m"
(0x73)
"#"
(0x23)
––––––
Sensor
response
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
ASCII distance measurement value
State
"#"
(0x23)
max.
120ms
10'000's 1'000's 100's tens ones tenths