Leuze electronic ODSL 30 Series - Page 27

Description ODSL 30
Leuze electronic ODSL 30 25
TNT 35/7-24V
For this purpose:
• the active/reference input (pin 2) must be connected to the inactive state (default: 0V)
or it must be open.
• the active/reference input (pin 2) must be configured as an activation and referencing
input:
Input Menu -> Input activ/ref -> input activ/ref Activation + Ref
Synchronous measurement value query 5 digits, resolution 1mm:
Synchronous measurement value query 6 digits, resolution 0.1mm:
Notice!
To make the laser beam visible for adjustment purposes and to view measurement values
on the display, the
• active/reference input (pin 2) can be connected to the active state (default: 24V) or
• the sensor can be activated with the command "A" (see page 26) or
• the active/reference input (pin 2) can be temporarily configured via the menu as a ref-
erence input:
Input Menu -> Input activ/ref -> Input activ/ref Referencing
Possible errors and their causes
Instead of a synchronous measurement, an asynchronous measurement is performed.
Possible causes of the error: the synchronous measurement command was set by the acti-
vated, i.e. the measuring, sensor. Instead of the synchronous measurement, an asynchro-
nous measurement was performed (corresponds to the commands "M" and "m").
Byte no. Response
time
1)
0123456789
Command
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
"S"
(0x53)
"#"
(0x23)
––––––
Sensor
response
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
ASCII distance measurement value
State
"#"
(0x23)
–
30
…
100ms
10'000's 1'000's 100's tens ones
Byte no. Response
time
1)
1) Depending on the configuration of the measurement time, see chapter 3.8 "Advanced
Menu (for software versions V01.10 and newer)", duration of data transmission not
included.
0123456789
Command
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
"s"
(0x73)
"#"
(0x23)
––––––
Sensor
response
"
*
"
(0x2A)
ASCII
address
"0…9",
"A…D"
ASCII distance measurement value
State
"#"
(0x23)
30
…
100ms
10'000's 1'000's 100's tens ones tenths