Page 10
Installation
Installation Checklist - Non Universal 120V Units
Install the cabinets by following these simple steps:
Step 1Mount the cabinets to the wall
Step 2Hook up the feed/line wiring
Step 3Hook up the load wiring
Step 4Wire the Relay Cabinet (OPTIONAL)
Step 5Hook up the control input wiring
Step 6Hook up the fluorescent control wiring, if required
Step 7Install the dimmer modules
Step 8Verify the dimmers are in bypass mode
Step 9Double check the wiring
Step 10Power up the system
Step 11Clear any faults that have caused any breakers to trip
Step 12Set the bypass switch to normal
Step 13Set up and Configure the control module
Installation Checklist - Non Universal 277V and
Universal Units
Install the cabinets by following these simple steps:
Step 1Mount the cabinets to the wall
Step 2Hook up the feed/line wiring
Step 3Hook up the load wiring
Step 4Wire the relay cabinet (optional)
Step 5Hook up the control input wiring
Step 6Hook up the fluorescent contorl wiring if required
Step 7Install constant modules (optional) or dimmer modules
Step 8If using universal modules verify the switches are in bypass mode
Step 9Double check the wiring
Step 10Power up the system
Step 11Clear any faults that have caused any breakers to trip
Step 12Disconnect power to cabinet if constant modules were installed
Step 13Install the dimmer modules if constant modules were installed
Step 14Set Bypass switches to normal if they were used
Step 15Set up and Configure the control module
To Next Page
Loading...
Need help?
General