a-2000 User Guide
a-2000 Page 45
Dimmer Cabinets with Digital Controls
Revision G November 2006
Step 9: Double Check the Wiring
Prior to turn on, verify that the following has been done correctly:
• Main feed wiring
• Load wiring
• Remote control wiring
• Correct wiring to any fluorescent dimmer ballasts
• Dimmers are set in the Bypass Mode
With all power and control wiring in place, and all dimmer modules or constant
modules installed, breakers off and bypass on, the system is ready for turn-on.
Step 10: Turn On The Power
Step 11: Clear Faults that have Caused any
Breakers to Trip
Step 12: 120 V Systems - Set Bypass Switches to
Normal
Note: If your system uses constant modules for testing in lieu of bypass switches,
replace the constant modules with the appropriate dimmer module.
To Next Page
Loading...
