Remove all color supplies
The printer is set for Color Lock Out printing in the Config menu. Try one of the following methods:
• Remove all color toner cartridges and photoconductor units.
Note: Do not remove the black toner cartridge or photoconductor unit.
• Press the up or down arrow button until Continue appears, and then press to clear the message and print
in Color Lock Out mode.
Remove paper from standard output bin
Remove the stack of paper from the standard exit bin.
Remove packaging material, check <area name>
1 Remove all packing material from the printer.
2 Make sure the fuser, transfer module, trays, and supplies are installed correctly.
3 Press the up or down arrow button until Show Areas appears, and then press .
Securely clearing disk space
The printer hard disk wiping process needs to recover. The message clears when all blocks are cleared.
Restore Held Jobs?
• Press the up or down arrow button until
Restore appears, and then press to restore all held jobs stored
on the printer hard disk.
• Press the up or down arrow button until Do not restore appears, and then press . No print jobs will be
restored.
Some held jobs were not restored
Press the up or down arrow button until
Continue appears, and then press to delete the specified job.
Unsupported disk
An unsupported printer hard disk has been installed. Remove the unsupported device, and then install a supported
one.
Unsupported mode, unplug and change mode
Make sure that the camera is in a valid mode for PictBridge.
Unsupported USB hub, please remove
Remove the unrecognized USB hub.
Troubleshooting
164
To Next Page
Loading...
Need help?
General
