Menu item Description
Portrait Height
3–14.17 inches
76–360 mm
Sets the portrait height
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
• 356 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
Feed Direction
Short Edge
Long Edge
Specifies the feed direction
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only if the longest edge is shorter than the
maximum width supported in the tray.
Reports menu
Reports menu
Menu item Description
Menu Settings Page
Prints a report containing information about paper loaded into trays, installed
memory, the total page count, alarms, timeouts, the printer control panel
language, the TCP/IP address, the status of supplies, and the status of the
network connection
Note: The page prints when this item is selected.
Device Statistics
Prints a report containing printer statistics such as supply information and
details about printed pages
Note: The page prints when this item is selected.
Network Setup Page
Prints a report containing information about the network printer settings, such
as the TCP/IP address information
Notes:
• This menu item appears only for network printers or printers connected to
print servers.
• The page prints when this item is selected.
Network <x> Setup Page
Prints a report containing information about the network printer settings, such
as the TCP/IP address information
Notes:
• This selection is available when more than one network option is installed.
• This menu item appears only for network printers or printers connected to
print servers.
• The page prints when this item is selected.
Understanding printer menus
90
To Next Page
Loading...
Need help?
General
