5
Width guide
6
Width guide release tab
1 Press the tray release latch to the left, and then pull the multipurpose feeder down.
2 Gently pull the extension out until it is fully extended.
3 Prepare a media stack for loading.
• Flex sheets of paper back and forth to loosen them, and then fan them. Do not fold or crease the paper.
Straighten the edges on a level surface.
• Hold transparencies by the edges, and then fan them. Straighten the edges on a level surface.
Note: Avoid touching the print side of the transparencies. Be careful not to scratch them.
Loading paper and specialty media
58
To Next Page
Loading...
