111
Chapter 6: Solving Printer Problems
Solving Printer Problems
002 Paper Jam
Remove Paper
Clear paper jam. Remove any debris from inside the printer.
005 Cover Open
Close Cover
Top Cover is open or not properly closed. Close the top cover.
007 Data Error Data transmission error in Serial Interface. Check the serial
settings on the function menu to make sure they are correct.
Check that the serial cable is properly connected at both ends.
6XX Machine Chk A hardware error occurred. If this happens, turn off the
printer, fix the paper jam or other problem, then turn the
printer back on. If the error occurs again, contact your point
of purchase, or see the printer registration card for the
number appropriate for your country.
FastDraft FastDraft font is selected.
Draft Draft font is selected.
Gothic Gothic font is selected.
Courier Courier font is selected.
XXCPI XX pitch is selected.
PS Proportional Spacing is selected.
Press Start The printer is waiting for you to press Start/Stop.
Printing... The printer is printing a demo or adjustment pattern.
Press Font/Pitch Press Font or Pitch.
Press Store Press Store to save your selection.
Operator Panel
Disable
The operator panel is disabled. To enable the operator panel,
see “Disabling/Enabling the Operator Panel” on page 48.
Paper Load Error The printer paper is incorrectly loaded. Remove the paper
and reload it. For help, see “Selecting and Loading Paper” on
page 49.
Feed Lever Error The paper select lever is in the incorrect position.
Message Description
To Next Page
Loading...
