13
Chapter 1: Getting Started
Getting Started
f Repeat steps a through e for each serial setting.
8
Press Quit to exit the function menu.
Verifying Serial Interface Settings
1 Make sure that forms are loaded.
Note: If you need help loading continuous forms, see “Loading
Continuous Forms” on page 62.
2
On the operator panel, press Menu.
3 Press Item ↓ or Item ↑ until Print Settings appears.
4
Press Start to print the current printer-function settings.
Note: If the settings are not what you expected, see “Using the
Function Menus” on page 31 to change them.
5 Press Quit to exit the function menu.
Printing the Demonstration Page
The following steps explain how to load a single sheet of paper so you can
print the demonstration page. If you want to load continuous forms, see
“Loading Continuous Forms” on page 62.
1 Turn the printer On.
Note: To temporarily stop the Paper Out alarm, press the Start/Stop
button.
2
Move the paper select lever up to the single sheets position.
To Next Page
Loading...
