Chapter 3: Using the Operator Panel
42
Using the Operator Panel
Stopping the Printer
To temporarily stop printing, press Start/Stop until the Ready light is off. The printer
finishes printing the current line and then stops printing.
To resume printing, press Start/Stop until the Ready light is on.
Advancing the Paper
You can use the operator panel to advance the paper when the printer is not printing.
To advance the paper:
• Press FormFeed to advance the paper to the Top-Of-Form (TOF) on the next
page or to eject the cut form.
Note: If Auto Tear Off is set to On or One Second, the form stops for one
second, then feeds to the Tear Off position.
• Press LineFeed to advance the paper to the next line.
• Press Micro ↓ or Micro ↑ lightly once for fine alignment, or press and hold to
scroll the paper up or down.
Note: If paper is sitting at the Tear-off position, pressing Form Feed will feed
the paper one page length.
Using Tear-off
The Tear-off function advances the perforation of a continuous form to the tear bar.
Auto Tear-off can be set to on, one second, or off.
To change the tearoff position, see“Changing Tearoff position” on page 72.
To Next Page
Loading...
