Chapter 3: Using the Operator Panel
48
Using the Operator Panel
Disabling/Enabling the Operator
Panel
All buttons except the Start/Stop, FormFeed, and Load/Unload buttons on the
operator panel can be disabled. To disable the operator panel:
1 Turn the printer Off.
2 Press and hold Micro ↓ and Micro ↑ and then turn the printer On.
Note: When any button except Start/Stop, FormFeed, or Load/Unload is
pressed while the printer is disabled, the Operator Panel Disabled
message appears on the display for approximately 2 seconds.
To enable the operator panel, repeat the above procedure.
To Next Page
Loading...
