31
Chapter 3: Using the Operator Panel
Using the Operator Panel
Using the Function Menus
This section describes the function menus and how to set them. To set functions:
1 Press Start/Stop.
2 Press Menu to enter the function menu.
3
Press Item ↓ or Item↑ until the function menu you want appears on the
display.
Note: The selectable function menu is different depending on the selected
data stream mode (IBM PPDS or Epson emulation) and the Interface
mode (Parallel, RS-232 or RS-422).
Note: If an
symbol appears on the display, the Next
button must be
pressed to enter the value level of that particular menu item.
4 Press Next
to enter that menu item.
5 Press Item ↓ or Item↑ until the value you want appears on the display.
6 Press Store to save the selected value.
Note: Press
Prev.
to exit each level of the menu.
Note: The currently selected default value is displayed with an asterisk (∗).
If you have to change the optional value in another function menu,
repeat steps 3 through 5. Otherwise, go to the next step.
7 To print the function setting, press Item ↓ or Item↑ until the Print Settings
message appears on the display.
8
Press Start/Stop to print the current setting values.
9 Press Quit to exit the function menus.
Note: If you have changed any settings, the printer performs a Power-On
Self Test. If you did not change any settings, the printer enters the not-
ready state.
To Next Page
Loading...
