29
Chapter 3: Using the Operator Panel
Using the Operator Panel
Micro ↑
• Advance the forms up 0.35 mm (1/72 in.).
When you hold this button for more than one second, the forms
move continuously until you release it.
Prev.
• Go back in a menu or return to the Main Menu.
Start/Stop
• Make sure the printer is online (ready state). The printer must be
online to accept data.
This is the only active button when the printer is printing. Press
this button to stop a print job. Printing continues until the current
line is completed. To resume printing, press Start/Stop until the
Ready light is on.
• Load the forms to the tear off position with the ready light on.
Load/Unload
• Load paper (cut or continuous forms) to the TOF position.
• Retract the forms to the tractor position.
LineFeed
• Advance the paper to the next line.
To move the paper continuously (while the printer is offline) hold
LineFeed for more than one second.
FormFeed
• Advance the paper to the TOF position on the next page.
• Load the forms to the TOF position.
• Advance the paper one form length.
Press this button: When you want to:
To Next Page
Loading...
