91
Chapter 5: Printer Options
Printer Options
Loading Continuous Forms in the Tractor 2
Feeder
1 Turn the printer On.
2 Make sure the paper path is clear. If a single sheet or envelope is
loaded in the printer, remove it.
3
Make sure AutoGap is set to On or Single AutoGap. For help, see “Set-
ting AutoGap” on page 44.
4 Make sure the paper select lever is pushed down in the
continuous forms position.
5
Notice how the manual feed tray fits onto the Tractor 2 Feeder. You
will need to remember this when you replace the tray later.
6
Lift up and pull out the manual feed tray to remove it from the Tractor
2 Feeder.
To Next Page
Loading...
