Lexmark MS826 - Page 218

Action Yes No
Step 18
Reinstall or replace the motor. See
“Motor (mailbox transport)
removal” on page 666.
Does the problem remain?
Go to step 19. The problem is
solved.
Step 19
Check the mailbox belts for improper installation, wear, and
damage.
Are the belts properly installed and free of wear and damage?
Go to step 21. Go to step 20.
Step 20
Reinstall or replace the aected belt. See
“Mailbox belt removal”
on page 678.
Does the problem remain?
Go to step 21. The problem is
solved.
Step 21
Enter the Diagnostics menu, and then navigate to:
Output bin quick feed
Perform the feed test on each optional bin.
Does the error occur in any of the optional bins?
Go to step 23. Go to step 22.
Step 22
a Remove the optional bins.
b Reinstall the optional bins one at a time, and then identify which
bin is causing the error.
Does the error occur in any of the optional bins?
Go to step 23. Contact the next
level of support.
Step 23
Make sure that the controller board of the aected optional bin is
properly installed. Reseat all the cables on the controller board.
Does the problem remain?
Go to step 24. The problem is
solved.
Step 24
Check the aected controller board and its connector pins for
damage.
Are the bin controller board and its connectors free of damage?
Contact the next
level of support.
Go to step 25.
Step 25
Replace the bin controller board. See
“Mailbox controller board
removal” on page 667.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
4064
Diagnostics and troubleshooting
218