Lexmark T65x and X65x Mono Product Study Guide Rev 1.47
For Training Purposes Only 6/3/2009
13
6. Check the Quick Test Page for any sign of misalignment by checking the diamonds at the top left and
top right of the test page for equal distance from the top of the page. If necessary, rotate the
printhead to the left or right and tighten down the mounting screws and check for proper alignment
again by running another Quick Test Page. This procedure may take two or three attempts before you
get satisfactory results.
7. When you have the correct adjustment, ensure that the printhead mounting screws are properly
tightened.
To Next Page
Loading...
Need help?
General
